![]() ![]() The LED is a very low current bulb and will not cause the vehicle's battery to drain, even when left unattended for extended periods. This serves as a visual deterrent to the potential thief. Whenever the system is armed, the dash mounted LED indicator will slowly flash.Any mild impact to the vehicle's glass will cause the alarm to sound a short series of warning tones. Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle, with "Dual Stage".If the potential thief left a door opened, the siren will sound for six 30 second cycles, then re-arm and ignore the opened door. The siren will continue to sound for 30 seconds, then stop and automatically re-arm the vehicle. Opening any door, hood or trunk will cause the alarm to immediately sound.The siren will "chirp" once, the vehicle's parking lamps will flash once, the doors will lock (optional), and the dash mounted LED will begin to slowly flash. If you wish to arm the system immediately, simply press and release the ARMING button on the keychain transmitter.OPTION NOTE: If the optional (not included) power door lock interface has been installed, the alarm control module can be programmed to.Automatically lock the doors during step 3 above, or Lock the doors only when the transmitter is operated. At this time, the dash mounted LED will begin to flash slowly, providing a visual indication that the system is fully ARMED. In 30 seconds, you will hear a single short "chirp" from the siren and the vehicle's parking lamps will flash one time, indicating the system is ARMED.As an added convenience, the automatic passive arming will not begin until all doors and trunk lid are closed, allowing passengers to exit the vehicle at their convenience. ![]() The dash mounted LED will begin to flash rapidly, indicating that the system is automatically (passive) arming.Turn off the engine, exit the vehicle, close and lock all doors, hood and trunk.Again, closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. NOTE: If the siren "chirped" three times when Locked, then one of the entry points (hood, trunk, doors) has been left opened. All that is required is a light push to the button. WARNING! Excessive pressure on the transmitter buttons will damage the internal components on the circuit board. The siren will "chirp" once, the vehicle's parking lights will flash once, the doors will lock (optional), and the dash mounted LED will begin to slowly flash. Press and release the Lock button on the keychain transmitter.Turn off the engine, exit the vehicle, and close and lock all doors, hood and trunk.Operating the Prestige APS25C Remote Security System ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |